Quantcast
Channel: EngineerZone: Message List
Browsing all 22625 articles
Browse latest View live

SSM2412 Absolute maximum rating of the input pin.

hiDescription of absolute maximum rating of the input pin is not found in datasheets.Absolute maximum rating of the input pin of the SSM2412 is VS ? It is nice to teach us.

View Article


Vx and VxGND pin of AD7606

Hello, Now I consider to use AD7606.AD7606 has 8 channels for input, but I don't use all of the channels.In the datasheet, for the Vx and VxGND pin which is not be used, it is recommended to connect...

View Article


Re: Looking for a lost bit in SIC_ISR

Hi Nick, Thanks for the  details. I understand your problem, but without looking into code flow, we cannot get clear understanding of issue. BTW, do you have synchronisation instructions (ssync()) at...

View Article

The full scale of AD7687

The url http://www.analog.com/en/content/Tested_Product_Combinations/fca.html is about tested amp/adc driver.I can't understand:How are ENOB bits equal 15.5 if ADI recomended the schema for AD7687...

View Article

can any one help me to compute the power consumption in op amp and other...

Is there any exact formula or tool to compute power consumption in analog devices???

View Article


Typical standby power

How to calculate Typical standby power?? Is it applicable for all analog devices???

View Article

Dimensions for Evaluation Boards

Dear all, May i know the size (width & height) for the following Evaluation boards :- i) ADL5350- EVALZ – Frequency Mixer Evaluation boardii) ADF4360-3EB1Z – PLL_VCO Evaluation board iii)...

View Article

Image may be NSFW.
Clik here to view.

Re: can any one help me to compute the power consumption in op amp and other...

Hi Sindhu, If you just want to compute the power consumed by the device itself (power dissipation) then you can refer to the formula below:You may also want to visit this link to see a sample...

View Article


Re: Switch configuration (NO / NC / NC&NO / NA(Not Applicable)

Hi Joe,     Thank you for the support..RegardsSindhu.V

View Article


Re: can any one help me to compute the power consumption in op amp and other...

Hi Emman,         Thank you for your valuable response. I need the datas on die size and transistor count of analog devices. where i can fetch those information??

View Article

Re: Ultra low power data collection - reading strain guage

Hi Lionell, No worries on keeping commenting. It always help because, it can be give a better understanding of the problem. I found an ADC that is differential that is supplied from 2.5V to 5.5V. The...

View Article

Re: RMS-DC converter AD8436 single supply questions

Hi John, Glad to be of help. Also, we are encouraging our customer to mark our answers if they find it helpful or correct answer.Good luck to your work and experiments! Best regards,Emman

View Article

Re: Product Information for Operational Amplifier

Hi Prasath,  I asked about the information you're requesting, and unfortunately, you will need to course this request through your local sales representative (see this link). They will determine which...

View Article


Re: Issue with my ad7609, busy signal o/p..

Hai Jonathan, Thank you for your response.In the attached document the output data in 2's complement in decimal form, before converting to voltage is also added.Please refer and verify. Please aslo...

View Article

ITU BT.656-4 input can't be detected by ADV7511

Hi,  The video stream goes like this: DVD(YCrCb) -> ADV7180 (8-bit ITU-R BT.656 YCrCb 4:2:2 embedded sync) -> (D7~D0, set V/Hsync and DE to GND) ADV7511. The setting for ADV7180 mostly are the...

View Article


Re: HDMI TX ADV7511W

Thanks GuenterL.

View Article

Re: Vx and VxGND pin of AD7606

Hi, Karen Thank you for your information.I will follow your advise. Best regards,Nom

View Article


Re: Wrong response in ADF4360-0

As you show in fig.2 , your PLL is not locked!!!So, try to recalculate your PIF (feedback filter). Use ADIsimPLL - nice program!!!Best regards!!!Alexius.

View Article

5 questions: Multiple AD9361 RF PLL Sync, External LO and others

Hi1-From the documentation: The ability to synchronize RF local oscillators between multiple AD9361 is not available. Sync between multiple chips is supported only for Baseband PLL...

View Article

Re: Determine Blackfin Derivate and Silicon rev from App

i'm also interested to knwo the chipid/dspid values for some derivates of BF-Familybut the links are obsolete, and not valid,is there any info ????

View Article
Browsing all 22625 articles
Browse latest View live


<script src="https://jsc.adskeeper.com/r/s/rssing.com.1596347.js" async> </script>