Dear Analog Devices Team,
We are using ADSP-TS101SAB1Z000 in one of our design, We have made strap pin /BMS as "0" so that the system boots from EPROM/Flash immediately after reset.
In the ADSP-TS101 development platform the Flash used for booting has a JTAG connection.
We are using S29AL008J55TFI010 - ( NOR Flash 8 Megabit, Boot Sector Flash Memory) flash in our design and it doesn't have JTAG connection.
So I request your feedback for the following quires.
- Is it possible to flash the boot code into the flash using Emulator through VisualDSP++ ?
- Or, Do we have to use 8-Bit EPROM only to store the boot code ?
Request you to provide any document which clearly mentions the booting requirement of the ADSP-TS101.
Awaiting your reply...............
With Regards
Bhanuprakash
Member Technical - Hardware