Hi,
I have a rather simple question. However, I was unable to figure it out by myself.
The evaluation board is supposed to fit in some edge card connector. I was wondering if anybody knows the matching type of connector? I checked the product trees of many manufacturers and the stock of various distributors in Germany, but I simply couldn't find any connector that fits... Either the pitch is wrong or the pincount does not match.
I plan the use of these boards in a regulation loop where they will be mounted on another PCB. The only alternative I have in mind is a 2.54mm 2 row pinheader which I would have to solder on the pads.
Best regards,
Martin Krellmann.
