Hello there,
I am a newbie and I have problems using the AD9548 evaluation software. Hope someone can help me in this.
So far I was able to see that the sysclk was locked and ref A is valid for use, and I have set up the chip in freerunning mode. The external clock is 19.44MHz, system clock is 972MHz, clock doubler off, Feedback Divide N = 50, freerunning frequency is set to 155.52MHz. However I could not get any output clocks appearing. What could go wrong?
0x0d01 = 0x11
0x0d0a = 0x01
0x0d0b = 0x00
0x0d0c = 0x88
Also, I have used the excel spreadsheet to calculate the digital loop filter coefficients. However I don't know how to enter the values into the software as alpha0, alpha1, alpha2, alpha3, etc. The software requires me to enter in hex values. Can someone shed a light?
Attached is the spreadsheet.
Thank you.
Regards,
JoyceT