Dear All,
First let me wish a Merry Christmas to all of you.
We wanted to try the linux demo IIOscope. Therefore we downloaded the image from the following link
http://wiki.analog.com/resources/tools-software/linux-software/zynq_images
File name is Zynq_image_8gb_2013_12_12 .... ( see Zynq_image.jpg )
then after spending sometime creating an SD card we ended up with this ( see SD-card.jpg).
This could not run on our Zedboard FMCOMMS2 but run on our FMCOMMS1 board. Checking more in detail, the readme.txt dates back to April ( April fool in December ? Is that climate change ).
README: Release April 18th 2013
This release supports following targets.
zynq-zc702-adv7511-xcomm
zynq-zc706-adv7511-ad9250-fmc-250ebz
zynq-zc706-adv7511-xcomm
zynq-zed-adv7511-pmod-ad1-da1
zynq-zed-adv7511-xcomm
Copy target/BOOT.BIN and target/devicetree.dtb to the
root of the BOOT FAT32 partition.
The Linux kernel uImage is the same for all targets.
On the link above much more images are listed:
ZC702 & the ADV7511
ZC702, ADV7511 and the AD-FMComms1-EBZ board
ZC702, ADV7511 and the AD-FMComms2-EBZ / AD-FMComms3-EBZ (AD9361) board
ZC706 & the ADV7511
ZC706, ADV7511, AD-FMComms2-EBZ / AD-FMComms3-EBZ (AD9361)
ZC706, ADV7511 and the AD-FMComms1-EBZ board
Zed board & the ADV7511
Zed board and the AD-FMComms1-EBZ board
Zed board and the AD-FMComms2-EBZ / AD-FMComms3-EBZ (AD9361) board
Zed board and the AD-FMCMOTCON1-EBZ board
Zed board and the FMC-IMAGEON board
So I guess Santa needs to update the image may be he was too busy.
Best regards,
Dan